Garage Door Repair: Troubleshooting

[ad_1]

The installation of a garage door system can be very expensive, as can their replacement. That's why this can be a headache if your current unit is not working as well as it was and you can not point the finger at the cause. If you want to make important decisions, check out this garage door repair and troubleshooting checklist.

1. Look around you

The first thing to do is to look for external causes. You would be surprised how many problems can be caused by small tools or equipment that fit somewhere in the assembly.

2. Cleaning

As a general rule, a thick viscous substance accumulates on the rollers and rails of the garage door. This is the result of exposure to dust and lubricants used for maintenance. The resulting friction can cause the equipment to lock up. You can remove the substance using ordinary household cleaning products or mild soap. When using a roller cleaner, be sure to dry it well.

3. Lubricate

Sometimes the mechanism does not work properly because the moving parts are not lubricated enough. Lubrication should be done twice a month. avoid contact with the plastic bearings. Powdered graphite can be used on runways and domestic oil is good for rollers. Be careful when doing this process to avoid any problems described in step 2.

4. Check Springs

You should also check the cables and springs for extension. The pull springs are those on each side of the door and start from a pulley. Make sure the cables and springs are not rusted. If this is the case, you may need to call a local professional to determine if they just need to be cleaned or need to be replaced. Be sure to replace the springs in pairs to avoid imbalance. However, there is another system of springs for most garage systems, namely the torsion spring. It is a high voltage spring that would have been complicated to repair; In this case, a professional technician may be required.

5. Tighten Down

Garage doors, like anything, are prone to wear. Bolts, hinges and screws are no exception, especially since your garage door is used very often. Check all screws and bolts involved in the opening mechanism of your garage door. There are times when tightening can solve the problem. If they can not be tightened due to loose holes, you can use pieces of wood as filling material. Check to see if the hinges sag. Adjust them or replace them if they need attention. For side hinged garage doors, make sure that the wood on which the hinges are attached is also in good condition.

6. Examine the Tracks

Look for bumps and bumps in the metal tracks. The rails guide the roll, so they are very important. Also check the alignment and press the affected areas to put them back in place if possible.

Garage systems have 7 feet of metal, plastic or wood, usually a combination of all three. It may take some detective work to find out what's wrong. With this checklist, you will have more ease. If you are not a jack of all trades, consult a garage door repair facility or visit the website for an estimate of repairs.

[ad_2]

Source by Kent Swanzy

About the author

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.