Quilling Tools – Create your own worksheet and design guide


If you want to make more than one or two pieces of quilling, you need to buy one of the work tables And quilling design guides are currently available. These are high-quality dense self-adhesive or durable foam panels that are sturdy and made to last for years. The design guide helps you keep your feathers straight while assembling, which is very important when working with symmetrical patterns such as snowflakes. However, if you are working with a group (Scout group, church group, craft club, etc.), it is not always practical to buy each member of his own table And its design guide. You can do them instead.

A simple and temporary quilling card can be made from a tough sheet of cork, plastic foam, corrugated cardboard or other similar material. A good size is 6 "x 8", but use what you have. For my quilling courses, I took inexpensive 12 "x 12" cork squares, cut them into four 6 "x 6" squares and refined them with duct tape. These work fine, and if one escapes me, it can easily be replaced. Go green with a corrugated board sticker cut from a box that was headed to the trash. When it has too many holes to be useful, just place it in the recycling bin.

Wax paper makes a cover sheet usable for your worksheet. It is useful and certainly quite cheap, however, if too much glue is used and the dies are accidentally glued onto the waxed paper, the wax can be designed when it is removed. I prefer to use transparent plastic sheets cut from scrap metal (think of old desktop protectors and transparencies) or recycled plastic packaging. Even the heavy food bags will work. You can either pinch the panel of the work table in place, or wind it up and stick it to the back. To use, simply slide your shimming profile under the cover sheet (plastic or waxed paper), secure it in place and assemble your skilled worker on the pattern.

For a symmetrical work, a design guide can be created from A piece of graphic paper cut to fit your quilling work table. Count the squares horizontally and vertically to find the center point of your graph paper. Using a ruler and a black pen or a fine tip marker, draw a vertical, horizontal line that cuts the center point to divide your graph paper into quarters. This will give you angles of 90 degrees. Then, using the lines of the graph paper as a guide, draw an "X" on the paper that crosses the center point and divides the quarters. This will give you angles of 45 degrees. Continue drawing lines crossing the center point to divide your paper into as many sections as necessary for your pattern. Circles can be added to the guide using a compass or circle template. Be sure to center the circles on your guide using the intersection of the lines as the center of the circles.


Source by Charlotte Canup

About the author

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.